Rcbs High Capacity Case Trimmer Kit Bedienungsanleitung PDF herunterladen (Seite 5)

- 5 -

2. Adjust the 8-32 SHSS Adjustment Bushing Stop so that approximately 1/8” is exposed to the left of the

Adjustment Bushing.

3. Slide the Adjustment Bushing towards the Cutter roughly ½” and temporarily lock it in place with the 8-32 SHSS.

4. Loosen the two 6/32” SHCS with a 7/64” hex wrench that secure the Case Holding Collet assembly to the Base.

This allows the Collet Assy to be moved to the right.

5. Slide the Cutter Assy to the LEFT until the Adjustment Bushing Stop is up against the Cutter Sleeve. Holding the

Stop in position, slide the Case Holder assembly to the RIGHT, until the case mouth contacts the Cutter. Secure the two

6/32” SHCS to lock the Case Holder Assembly into place.

6. Refer back to your measurement of the overall length of the case. One complete revolution of the Adjustment

Bushing stop Set Screw is equal to @.030”. NOTE: Do not make large adjustments of the set screw. You can always re-

adjust to trim more off of the case but you cannot put back what has already been trimmed off! If you need to remove

.015” from the length of the case, unscrew the Adjustment Bushing Stop Set Screw, ½ turn counter-clockwise. NOTE:

This is a trail and error operation to adjust for overall length.

7. Trim the case and remove it from the Trimmer to check the over all length.

8. Re-adjust the Stop Bushing Set Screw as necessary to achieve the desired case over all length measurement.

1 2 3 4 5 6 7 8

Keine Kommentare

Rcbs High Capacity Case Trimmer Kit Bedienungsanleitung Seite 5