Rcbs High Capacity Case Trimmer Kit Bedienungsanleitung PDF herunterladen (Seite 4)

- 4 -

TRIMMER ASSEMBLY

1. Select a solid bench on which to mount the High Capacity Trimmer Kit. You must use the four mounting holes

(use casting as a template). Mounting hardware not included. Leave enough room to the left and right of the Trimmer

Body to operate the Collet Handle and Trimmer Handle.

2. Place the Handle Assembly on the Cutter Shaft and secure the 10-32 Button Head Cap Screw with a 1/8” hex

wrench (not included).

3. Select one of the three included Pilots for the cases you are about to trim. Install the desired Pilot into the Cutter

Head and secure the 8-32 Socket Head Set Screw with a 5/64” hex wrench (not included).

4. There are two case holding diameters machined into the case holder Collet. The smaller diameter is for the .408

CheyTac® and the larger diameter will accommodate the .416 Barrett® and .50 BMG.

TRIM LENGTH ADJUSTMENT

1. Taking a case that has been resized, measure the over all length of the case and write this measurement down.

Place the case into the case holder Collet, apply rearward pressure on the case and tighten the Case Holder Collet Draw

Pin.

1 2 3 4 5 6 7 8

Keine Kommentare

Rcbs High Capacity Case Trimmer Kit Bedienungsanleitung Seite 4