Rcbs Bullet Feeder - Rifle Bedienungsanleitung

Bullet Feeder – Rifle PRODUCT INSTRUCTIONS

- 10 - CAM Plate The CAM Plate on the upper portion of the Case Activated Linkage System is used to stroke the Push Bar on the Bullet Seating Die. Wit

- 11 - TROUBLESHOOTING If correctly oriented bullets fall off of the sorting plate too early, change to a shallower Bowl angle adjustment. Move the B

- 12 - Dust Cover RCBS does not offer a specific Dust Cover for the Bullet Feeder. However both dust covers for the Mini Grand (pn#86886) and The G

- 13 - ITEM NO.PART NUMBERDESCRIPTION QTY.1 781205 Support Foot 12 781208 Support Tube Lower 13 181219 Tube Cap 24 181233 10-24 x 1-1/2 SHCS 25 781

- 14 - ITEM NO.PART NUMBERDESCRIPTION QTY.ITEM NO.PART NUMBERDESCRIPTION QTY.1 109603 10-32 Hex Nut 5 181257 Continuous Spring (22) 12 109604 1/4-28 H

- 15 - ITEM NO.PART NUMBERDESCRIPTION QTY.1 181230 6-32 x 3/8 BHCS 2781244 Bullet Drop Tube 22 Cal 1781222 Bullet Drop Tube 38 Cal 1781246 Bullet Drop

- 16 - PRECISIONEERED RELOADING EQUIPMENT We think that we make the very best reloading equipment in the world. If you agree, please tell your fr

- 2 - WARNING Before using the RCBS Bullet Feeder – Rifle, read these instructions carefully to fully learn how to safely operate the related reloadi

- 3 - WARNING/ CAUTION PRIMERS AND POWDER • Store primers and powder beyond the reach of children and away from heat, dampness, open flames and elec

- 4 - UNPACKING Refer to the list below to identify parts as you unpack your new Bullet Feeder – Rifle. The foam inside the Bowl Assembly is for ship

- 5 - ASSEMBLY Note: Reference the part schematics on pages 13-15 for more information. Attach the Lower Support Tube to the Support Foot using two

- 6 - System found attached to the Powder Measure. Remove the rear Button Head Cap Screw (B). See Photo 5. Photo 5 Place Cam Plate Assembly onto

- 7 - relative to the Powder Measure Assembly so that the Cam Plate Assembly (A) (installed on the Powder Measure) will activate the Bullet F

- 8 - Photo 13 To install wires on the Switch Block, connect the green wire (A) to the lower outside and the black wire (B) to the upper inside conn

- 9 - ADJUSTMENT Note: Reference the part schematics on pages 13-15 for more information during assembly and installation. Bullet Seating Die At the